The internal humidity of the oil fume pipes is very high, and the oil fume itself is prone to breed bacteria. Therefore, the breeding ground of the food fume pipes in the cafeteria can easily form a breeding ground. Regularly cleaning the oil fume pipes is not only for fire prevention, but also for food hygiene.
The cleaning content includes cleaning of exhaust pipes, cleaning of purifiers, maintenance of exhaust systems, cleaning of exhaust fans, exhaust hoods, ladle cleaning, water transportation systems, fire protection nets, exhaust ports, and cooktop surfaces. The key part of cleaning is the smoke exhaust duct which is synchronized with the smoke hood through the smoke exhaust port. We will focus on thorough cleaning of the interior of parallel flues. The main method adopted by the oil fume pipe cleaning machine
is to enter the flue for cleaning. The advantages and characteristics are: For the narrow exhaust port, which cannot be manually entered into the flue or because the flue itself is complicated, narrow, and cannot be cleaned manually, but there are major hidden dangers, special equipment can be used for cleaning without leaving a dead end. To dispel the doubts and concerns of customers and eliminate all potential fire hazards.
Cleaning method for oil fume pipeline cleaner:
(1) Manual entry method: The premise is that the pipeline is sufficiently spacious. Generally, this method can be used for oil fume pipes with a diameter of more than 40 cm. The specific method is to manually carry an oil shovel, scraper, and lighting tool to enter the interior of the pipe. It should be noted that while the workers are inside the pipeline, they must ensure that the fan is turned off and the power is turned off. Generally, a warning sign is placed at the power supply to prevent someone from turning on the power by mistake.
(2) Opening method: If the pipe width is not enough, manual entry is too difficult, or it is impossible to enter at all, adopt the opening method, which is measured and judged by our company's professional staff to determine the appropriate opening position and size, and then use Professional pipe opening tools are used to make holes. After Z, these holes can be used to clean the inside of the oil fume pipe.
(3) Equipment cleaning method: This method is special, only suitable for less oily and lighter pipes. You can first configure the oil fume catalyst and spray the inside of the pipe with a professional water gun. After the catalyst reacts with the oil fume, rinse with a high-pressure water gun. , And then wipe with the inside of a long hair brush. This method is relatively efficient and low in cost, but it has limited limitations.
(4) Disassembly and cleaning method: Compared with the previous three methods, this method is difficult to operate. For some units with high requirements and heavy oil fume, our company will make technical judgments, measure the pipe disassembly nodes, and then thoroughly Cleaning, reassembly and assembly after cleaning, the word method is difficult Z, but it is also a thorough way to clean Z.
(5) Artificial suspension airborne method: The previous four types of methods are directed to the cleaning method of the horizontal pipe. Although the accumulation of oil fume in the vertical pipe is not as serious as the horizontal pipe, the difficulty of cleaning is also very wide. Special artificial airborne cleaning methods are required. First, the technicians of our company dismantled the top and bottom of the pipeline, and then fixed the high-altitude operation god rope on the top. The workers have excellent high-altitude seat belts, and then hang the operation from above and below to remove the oil from the vertical pipe.